PSTN switch-off: will your alarm, card machine and other devices still work?

News and VoIP

Moving your calls to VoIP is usually the simpler half of the PSTN switch-off. Sorting everything else plugged into a phone line is the harder half. These could include devices like the intruder alarm that reports to a monitoring centre, the card machine in the back office, or the emergency phone in the lift. BT's analogue network is due to close on 31 January 2027, and any device still dialling out over it needs to be checked before then. For most of this equipment, the person to call is the supplier, not your phone provider.

How the PSTN switch-off affects equipment on your line

Traditional analogue phone lines carry voice and signalling tones over a connection that can also supply power from the telephone exchange. Many older alarms, card terminals and fax machines use those tones to transmit information. When calls move to VoIP, audio compression, timing changes and other differences in how signals are carried can interfere with the data. A device that worked reliably on an analogue line might therefore fail on a digital connection.

After the digital switchover, a device needs either an adaptor its supplier has approved for a digital line, or its own internet or mobile (4G) connection. But which route you follow depends on the device, not on your phone service.

Your phone provider can't make that decision for you. Providers don't know which devices are connected to their lines, so finding them is the business's job. Often called the BT landline switch-off, the change affects businesses using traditional telephone services delivered over Openreach's network, even if they pay another provider. It doesn't mean all copper cabling is being removed in January 2027. Some broadband services will continue using copper for part of their connection.

Find every device that uses a phone line

Device lines are easy to miss because they often sit on a separate account, are billed by the alarm company, or were installed by a previous occupier.

  • List every line you pay for. Ask your provider for each number and line on the account, including any that nobody answers.
  • Walk the building. Check the alarm panel, comms cupboard, lift motor room, reception, the back of the till, the plant room and any gate. Look for anything with a cable running into a phone socket.
  • Match each line to a device. A line with no handset on it is often an alarm, lift or card machine. Don't cancel a line until you know what it serves.
  • Ask each supplier in writing. Will the device work on a digital line? If not, what replaces it, what will it cost and how long is the lead time?
  • Test after each change. Send a test signal to the alarm monitoring centre, make a test call from the lift and put a card transaction through.
DeviceHow it usually uses the lineTypical replacementWho to ask
Burglar alarmA communicator dials the alarm receiving centre, or a speech dialler calls keyholdersIP, 4G or dual-path communicatorAlarm installer or monitoring company
Fire alarmA communicator sends fire signals to the alarm receiving centreIP, 4G or dual-path communicatorFire alarm maintainer
Card machineOlder terminals dial the payment processorBroadband, Wi-Fi or 4G terminalPayment provider
Lift lineAn autodialler connects the lift car to a 24-hour rescue service4G autodialler with battery backupLift maintenance contractor
Telecare or personal alarmThe alarm unit dials an alarm receiving centreDigital or 4G alarm unitTelecare provider
Door entry systemThe intercom rings a phone, which opens the door with a keypress4G or IP intercomDoor entry installer or managing agent
Franking machineThe machine dials out for postage credit and rate updatesInternet (LAN) connection or a newer modelFranking machine supplier
Fax machinePages travel as modem tonesFax-to-email or an online fax serviceYour phone provider

Burglar alarms

A monitored burglar alarm usually has a communicator (sometimes called a digicom or dialler) that sends a coded signal to an alarm receiving centre (ARC) over the phone line. Simpler systems use a speech dialler that rings a keyholder's mobile with a recorded message. Leading up to the digital switchover, both systems need checking because they may stop reporting alarms when their analogue connection is replaced, without anyone noticing immediately.

The usual fix is to replace the communicator with one that signals over the internet, the mobile network or both. A dual-path communicator uses two routes, typically broadband and 4G, which ensures a signal can still get through if one fails. Your installer can usually fit one without touching your phone system.

But check your insurance before agreeing a replacement. Insurers commonly set a minimum signalling standard for monitored alarms, and many treat dual-path grade 3 (DP3) as the benchmark, so ask your broker or insurer to confirm the proposed set-up. A bells-only alarm that never dials out isn't affected.

Fire alarms

A monitored fire alarm uses a communicator to send alarm and fault signals to an alarm receiving centre (ARC), which follows an agreed response procedure. Depending on the arrangement, this may involve contacting keyholders or notifying the fire and rescue service. If that signal can't get out, the alarm may still sound inside the building, but the monitoring centre won't receive the alert. This is a more serious issue at night or when the premises are empty.

Fire safety law places the duty to keep fire detection equipment maintained on whoever is responsible for the premises. Ask your fire alarm maintainer to confirm that the replacement signalling meets current British Standard and insurer requirements, and to record the change in the system logbook. Some sites share one communicator between fire and intruder alarms, so the two upgrades could be a single job.

Card machines

Most card terminals sold in recent years connect over broadband, Wi-Fi or mobile data, and these aren't affected. The landline switch-off mainly threatens older dial-up terminals, which call the payment processor over an analogue line. A terminal with a cable running into a phone socket is a clue it might be affected.

Don’t limit your audit to your primary pay-point. You might have a spare terminal in a drawer, a back-office unit used for phone orders or a machine that is brought out for events. There’s also a risk you have broadband terminals that fall back to dial-up when the internet drops, so ask how that backup will work after the switch.

Your payment provider, not your broadband company, can confirm how each terminal connects and arrange a replacement. Check whether your rental agreement covers the swap and consider a terminal with 4G backup if a broadband fault would stop you taking payments.

Lift lines

Passenger lifts have an emergency phone, usually an autodialler in the car, that connects a trapped passenger to a rescue service at any hour. BS EN 81-28 sets out how these alarm systems should work, but neither the standard nor the Lifts Regulations prescribes a type of connection.

Lift emergency phones that use a dedicated analogue line need checking before the PSTN switch-off. The common replacement is a 4G autodialler with its own SIM and battery backup, fitted by your lift maintenance contractor. After the change, make a test call from the car and confirm who answers it.

Your duty to keep a lift used at work in a safe condition doesn't change with the line, so ask your contractor to record the work in your maintenance records. Lift engineers are likely to get busier as 31 January 2027 approaches, which is a good reason to book now.

Telecare and personal alarms

Telecare covers personal alarms, pendants and sensors that call an alarm receiving centre when someone needs help. For a business, this usually means care homes, supported or sheltered housing, landlords and homecare providers responsible for residents' alarms. Older units may still dial out over an analogue phone line, and some won't communicate reliably after migration. Fully digital telecare systems are the government's recommended long-term replacement, although the appropriate connection and backup arrangements depend on the installation.

Tell your phone provider which lines carry telecare and ask your telecare supplier to assess the equipment, monitoring compatibility and backup power requirements. Any replacement needs testing with the alarm receiving centre before the old connection is withdrawn.

Door entry systems

Some audio and video door entry panels and gate intercoms use a phone line to ring a handset or mobile when a visitor presses the button. Pressing a key on that phone then releases the door. Those keypress tones travel the same way as alarm signals, so a door release that works on copper could fail on a VoIP adaptor.

Replacements include 4G intercoms with their own SIM and IP intercoms that ring an app or desk phone over your network. Ask the installer which suits your entrance. In a shared building the managing agent may own the system, so check who's responsible before ordering anything.

Franking machines

Older franking machines can be affected by the analogue switch-off if they use a phone line to download postage credit or receive Royal Mail rate updates.

If you’re unsure about yours, ask your franking supplier whether your model can switch to a network connection or needs replacing, and check what your lease says about upgrades. Schedule the change around your mailing days so you're not left unable to top up credit.

Fax machines

Fax sends pages as modem tones, which run into the same problems over an internet connection as alarm signals. Some fax machines work through an adaptor, but results vary, so test before you rely on one.

First, check whether anyone still needs to receive faxes. If they do, fax-to-email delivers incoming faxes to an inbox as attachments, with no machine or analogue line. Fax-to-email is a £3 a month add-on with the Dial 9 Business Phone plan. However, fax-to-email typically only handles incoming faxes, so if you still send them, you'll need an online fax service for outgoing pages.

Other equipment that may use a phone line

The digital switchover can also affect CCTV with remote monitoring, cash machines, vending machines, building management systems, utility meters, telemetry units, nurse call systems and older phone systems with a remote maintenance modem. Some use dedicated analogue connections, while others have already moved to IP or mobile networks. If something has a cable into a phone socket and nobody knows why, find out what it does before the line changes.

Plan for power cuts and broadband outages

Traditional analogue phone lines can supply enough power for a basic corded telephone to work during a local power cut, although connected equipment may have its own power requirements. Digital phone services usually depend on powered equipment such as a router or adaptor, as well as a working connection. Without suitable backup power or alternative connectivity, calls and device signalling may fail during an outage.

For anything safety-related, agree on a plan with the supplier before the line moves. Options include:

  • Battery backup in the device, so it keeps running when the power goes.
  • A UPS for the router, if the device relies on your broadband.
  • A second signalling path, usually 4G, so a signal still gets out if the broadband fails.

This is also essential for reaching 999 during a power cut.

Frequently asked questions about devices and the PSTN switch-off

Will an analogue telephone adaptor keep my alarm working on VoIP?

Not reliably. An analogue telephone adaptor (ATA) lets an ordinary phone plug into a VoIP service, but alarms, card terminals and fax machines send data as tones that the conversion can distort. Unless the device supplier approves a specific adaptor set-up in writing and it passes a test, assume it won't work.

Our phones already use VoIP. Could anything still be on the old network?

Yes. Moving your phone numbers doesn't move a separate line used by an alarm, lift or card machine, and those lines are often on a different account or with a different provider. Check every line, not just the numbers your staff answer.

Can a mobile SIM replace an analogue alarm or lift line?

Mobile connectivity is an option for some alarms and lift emergency communication systems, but the equipment must support the appropriate service. Coverage inside the building, backup power, monitoring compatibility and the ability to make emergency calls all need checking. A specialist installer should confirm that the proposed solution meets the system's requirements.

Who pays to replace an alarm communicator or lift autodialler?

It depends on your contract with the equipment supplier, and it's normally separate from your phone service. Ask for the cost in writing, including any new monthly charge for a SIM or monitoring, and check whether your maintenance contract already covers upgrades.

Can I cancel the old line once a device has its own connection?

Only after you've tested the device on its new connection and confirmed nothing else uses the line. Check whether your broadband runs over the same line first, because cancelling one can end the other, and look for notice periods or early termination charges.

Still using an analogue business phone line?

If you haven't moved your business calls to digital telephony yet, Dial 9 can help you find a suitable replacement. Our hosted Business Phone system and SIP trunking services offer different ways to keep your business connected, depending on your existing setup.

Request a free callback and we can help you explore your options, check whether you can keep your current phone numbers and work out what's needed to make the switch.

A little bit about the author

I'm Adam W, or as everyone prefers to call me - Batman. I get a lot of satisfaction out of helping our customers and am committed to making their customer experience as positive as possible. When not offering support to our customers, you'll find me gaming, listening to music or running.